PWKR80-2RS SKF Cam Follower 80x35 M30x1.5 thread

PWKR80-2RS SKF Cam Follower 80x35 M30x1.5 thread

PWKR ...2RS design cam followers are based on double row, full complement cylindrical roller bearings. The stud head and a pressed-on flange ring guide the outer ring axially via the roller sets. This enables PWKR ...2RS design cam followers to accommodate relatively heavy constant axial loads that are induced when operating in an inclined or tilted position.

PWKR ...2RS design cam followers are supplied with a contact seal made of oil and wear-resistant acrylonitrile-butadiene rubber (NBR) on both sides. The seals are integral with the sheet metal angle rings and press against the flange ring and the stud head. The angle rings are pressed into the outer ring shoulder.

PWKR ...2RS design cam followers have a recessed hexagon at both ends of the stud that enables the cam follower to be held in place by a hexagonal key (Allen wrench) during mounting. In the centre of each hexagon is a re-lubrication hole for a press-in grease fitting or an adapter from a central lubrication system.

All designs are available with a concentric seat or an eccentric collar on the stud. An eccentric collar, which has a shrink-fit onto the stud, enables less stringent manufacturing position tolerances to be specified for associated components. An eccentric collar is identified by the letter E at the end of the basic designation.

PWKR80-2RS-SKF dimension chart - all dimensions in mm unless indicated.

d	D	C	B	G	Max Radial Dynamic Load (kN)	Max Radial Static Load (kN)	Limiting speed (r/min)
30	80	35	100	M30x1.5	64	91.5	2000